wanted,

[dave.owen]

wanted rear brake plate for plunger wheel, will buy or have rigid brake plate to swop

6 1/2 " reflector without glass, and rim

Dave
please pm if you have parts

[Vincent.vanGinneke]

I might have a bare plate with this oblong hole in it, it has no water excluder tin rim -if I remember correctly.

Vincent

[Vincent.vanGinneke]

found it,.. and it is VERY bare, only the plate and also warped.
But I can send you a tracing of the plate so you can alter the rigid one ?

[dave.owen]

thanks for the offer,I have one on my '52 plunger I could copy,if I have to

Dave

[stephen.fawcett]

Hi, I think I have one that is not needed, it does not fit any of my bikes!
I have been trying to upload a picture but can't seem to get it to load.
If you private message me your email I will forward a picture.
Regards
Stephen