Hi all,
Does anyone have a torque figure for 1953 350cc NH cylinder head bolts?
Happy new year to everyone
T
cylinder head bolits torque
-
Roger Gwynn
- Holder of a Golden Anorak
- Posts: 1810
- Joined: Tue May 28, 2013 11:34 am
- Location: Norwich, UK
- Contact:
Re: cylinder head bolits torque
No, there isn't one. Just reasonably tight, say 20-25 ft/lbs. Other views will be available!
Roger Gwynn, Membership Secretary, curator of the Machine Register and the works drawings. Director of Draganfly Motorcycles, Craven Equipment and Supreme Motorcycles mostly retired.
-
nevhunter
- Holder of a Platinum Anorak
- Posts: 5474
- Joined: Tue May 10, 2011 9:42 am
- Location: Victoria.. Australia.
- Contact:
Re: cylinder head bolits torque
Iron headd don't need re torquing if just Lapped properly. Solid copper gasket doesn't take up Much either. Sometimes oil leaks down under the heads of the Two bolts that are in the OIL inside the rocker covers. Careful remachining of the bolt surface in contact with the Head can alleviate that. Nev
Re: cylinder head bolits torque
Thanks guy's
Happy new Year to all
T
Happy new Year to all
T
Who is online
Users browsing this forum: Semrush [Bot] and 1 guest