ARROW SEAT LOCATING CUPS. T2658

[Trev Sellars]

The 2 Stroke spares stock is down to its last 2 of these cups. Had a bit of a run lately on these.
Does anyone know of a company that can press these out ? I can get them machined up from alloy or even made in a 3D printer.
Thanks

[JohnnyBeckett]

hi, it need a press tool made then you can make them on a press or a fly press

[Julian Murphy]

Who owns and where is the die set that was used to make these samples?

[JohnnyBeckett]

hi i was thinking you maybe able to get a metal spinners to make them ?

[bh.sprint]

Hi, It can't be that hard to make a tool to press them out. I made a tool to press the badge bezels out, it is in brass , so a bit easier pressure wise but I'd had no previous experience of making one. Also made the die for making the plastic suspension tops a few years ago, again no previous experience but got there in the end. Brian H.

[Trev Sellars]

Thanks for your suggestions but the price of making a tool and then making the parts is too expensive for the small number sold each year.
So, Ive had a go at 3D printing some prototypes. Not for the purist but they are very strong and work well. Ok they need a paint, but other than that they do the job.

[Julian Murphy]

Trev.

You are getting pretty handy with 3D printing.

Those seat cups look really good.

[Trev Sellars]

Thanks Julian, They will be at the Rally on SATURDAY ONLY!
If your there on Saturday, pop in and see me. Im in the Blue Renault Master 2 Stroke sales centre