is there anyone that can sypply a correct handlebar to a 1934 Ariel 1"
Regards Lars
Handlebar Ariel 1934
-
- Posts: 14
- Joined: Fri Feb 22, 2013 11:48 am
- Contact:
- brenton.roy
- Holder of a Golden Anorak
- Posts: 2056
- Joined: Sun Feb 27, 2011 1:13 pm
- Location: Adelaide, South Australia
- Contact:
-
- Posts: 14
- Joined: Fri Feb 22, 2013 11:48 am
- Contact:
Re: Handlebar Ariel 1934
Hi, Thanks, but i have the original, but its in bad condition, only good for pattern. Regards Lars
-
- Holder of a Nylon Anorak
- Posts: 234
- Joined: Mon Jun 27, 2011 6:41 am
- Location: Albany, Western Australia
- Contact:
Drags have what you are after, part No 6400-34 for £34.50 which seems reasonable otherwise if you rent a pipe bender, buy the tube, have a couple of goes getting the bends right, then chrome, it will cost more than that.
I did see a nice set done in stainless, he had an exhaust shop bend the tube and he ran the cables in the bars tidying it up if not worried about being super original.
He drilled a hole for the cable then used a pointed rod to shape the hole so it did not chew into the cables.
I am going stainless myself, saves a bit of stress in wet climate/winter spraying the chrome all over the bike with Inox all the time.
Look forward to seeing your bike.
Brett
I did see a nice set done in stainless, he had an exhaust shop bend the tube and he ran the cables in the bars tidying it up if not worried about being super original.
He drilled a hole for the cable then used a pointed rod to shape the hole so it did not chew into the cables.
I am going stainless myself, saves a bit of stress in wet climate/winter spraying the chrome all over the bike with Inox all the time.
Look forward to seeing your bike.
Brett
-
- Posts: 14
- Joined: Fri Feb 22, 2013 11:48 am
- Contact:
Re: Handlebar Ariel 1934
Hi, thanks. Have had this on backorder at Draganfly nearly 3 years.........
Have now made a handlebar in stainless, not 100% but good enought for me.
Will post pics when its ready.
Regards Lars
Have now made a handlebar in stainless, not 100% but good enought for me.
Will post pics when its ready.
Regards Lars
Who is online
Users browsing this forum: Google [Bot] and 1 guest