Page 1 of 1
Plunger to locate neutral. Leader Arrow gearbox.
Posted: Sat Feb 01, 2025 11:31 pm
by Richard B
I have found that the plunger which locates on the dimple in the change mechanism jams the mechanism. The gearbox works well without it. The engine/gearbox is from an old Leader. Was there some difference between the Arrow and Leader which is causing this? It would be good to have this positive neutral location.
Re: Plunger to locate neutral. Leader Arrow gearbox.
Posted: Sun Feb 02, 2025 10:57 am
by Roger Gwynn
Gearboxes are identical. You mean the T796 plunger, try a new one, readily available
Re: Plunger to locate neutral. Leader Arrow gearbox.
Posted: Sun Feb 02, 2025 2:42 pm
by will_curry
I'd wondered if Richard could be describing a defective neutral light switch, an option for Leaders.
The switch screws into the gearbox casing by the rear suspension.
Re: Plunger to locate neutral. Leader Arrow gearbox.
Posted: Sun Feb 02, 2025 3:02 pm
by Roger Gwynn
Yeah I wondered as well. Same as a Landrover part