Hello all,
I am about to start assembling my ‘57 S4 engine, planning ahead and reading up as much as I can. I have the Otto head gaskets, reading the assembly instructions I find the instructions a little ambiguous regarding the initial installation. The instructions are clear for the re-tightening after the initial run, but I am not clear on the initial assembly. I have looked on the Drags site but couldn’t find anything there, I am probably looking in the wrong place. Anyway, any advice appreciated. Thanks.
Head gasket
-
BrianReynolds
- Posts: 30
- Joined: Mon May 13, 2019 4:03 am
- Location: Manitoba, Canada.
- Contact:
Who is online
Users browsing this forum: Bing [Bot] and 1 guest