big end oil ways

[john.nash]

should there be an hole ( oilway), in the crankpin, where the rollers run;

crankpin.jpg (58.76 KiB) Viewed 3472 times

I can see where the oil goes in but not where it would come out !
I suspect mine is full of roller debris and sludge but i cannot find it to clear it and I don't want to take a file to it !

I have a brandnew polished conrod (£45 from an autojumble), and rollers and cage (from the club - Peter kemp; prince among men).. i just need to clean everything up

[nevhunter]

Should have hole(s). Not very large. That pin doesn't look the best to me. I'd consider investing in a new one. Nev

[adrie.degraaff]

This crankpin is for the bin, even regrinding and larger rollers won't bring you far.

[admin]

Was it a hundred quid for a new, standard, pin Adrie ?

[adrie.degraaff]

No, but I will bring one with me.

[admin]

I don't need oversize.
I have a NOS conrod.

[adrie.degraaff]

The oversize is the pin !!!!