Can anyone provide dimensions for the gearbox sprocket spacer 3112-33 for a CP gearbox, in particular the length, thankyou
David
Re: CP gearbox
-
david.anderson
- Holder of a Golden Anorak
- Posts: 1635
- Joined: Mon Mar 28, 2011 4:52 am
- Location: south coast NSW Australia
- Contact:
-
david.anderson
- Holder of a Golden Anorak
- Posts: 1635
- Joined: Mon Mar 28, 2011 4:52 am
- Location: south coast NSW Australia
- Contact:
Re: CP gearbox
I found an older post by Alan Moore which gives the width as .762" whereas the BA spacer is .435"
viewtopic.php?t=9604
David
viewtopic.php?t=9604
David
-
nevhunter
- Holder of a Platinum Anorak
- Posts: 5674
- Joined: Tue May 10, 2011 9:42 am
- Location: Victoria.. Australia.
- Contact:
Re: Re: CP gearbox
It makes sense that it would be longer. It's usually worn where the seal runs on it as it's not hardened, so I usually make a new one as a new old stock one would be soft also. The sprocket retaining nut when tight with tab washer ends up with the sleeve gear threaded end about '020" Proud. Nev
Who is online
Users browsing this forum: No registered users and 5 guests