Tips regarding rear wheel removal 1956 NH

[keith.mettam]

Of course Roger is right with respect to the frame numbers which correctly determine the model year.
Best wishes,
Keith.

[Kevin_RSA]

IMG_5450.mov

(25.12 MiB) Downloaded 24 times

IMG_5450.mov

(25.12 MiB) Downloaded 24 times

Hi Folks

Was about to take back wheel off, when I raised the wheel off the ground, I spotted the side to side movement was between the wheel and the swing arm, almost as if a shim was missing. Any ideas ?

[Mick D]

Hi

It's difficult to see from your video but somethings not right, if the wheel nut on the sprocket side isn't loose I would take the wheel and sprocket off and compare to the diagram on the Draganfly site:

https://draganfly.co.uk/product-categor ... arm-frame/

Regards Mick

[Kevin_RSA]

I think this one shows the gap a little clearer

[Kevin_RSA]

Hi

It's difficult to see from your video but somethings not right, if the wheel nut on the sprocket side isn't loose I would take the wheel and sprocket off and compare to the diagram on the Draganfly site:

https://draganfly.co.uk/product-categor ... arm-frame/

Regards Mick

I will try that tomorrow… thank you so much

[simon.holyfield]

Hi

It's difficult to see from your video but somethings not right, if the wheel nut on the sprocket side isn't loose I would take the wheel and sprocket off and compare to the diagram on the Draganfly site:

https://draganfly.co.uk/product-categor ... arm-frame/

Regards Mick

I've always been curious about this. Where there are two spindle washers, where do they go in relation to the FERC?

[Mick D]

I've always been curious about this. Where there are two spindle washers, where do they go in relation to the FERC?

Hi Simon

I've fitted one washer under the head of the nut, another on the inside of the PRF and sandwiching the FERC between it and the 'spacer outside sprocket' (4233-56).

No guarantee that it's correct but it seems to work.

Regards Mick

[simon.holyfield]

That makes sense. Mine are both outside the prf ATM, which doesn't make sense to me!

[Julian Murphy]

I would say 4233-56, Spacer Outside Sprocket is missing?

[Mick D]

Hi

I think, if anything, 4233-56 is there but not clamping up on the short spindle, 4232-56, probably because a washer, 4234-56, is missing. Time will tell.

Regards Mick