Whatever was in the stores by '58......

This is mine - '56 to '58 (Type 16)

The spacer butts straight up to the speedo drive

Good question Vincent, It is installed long side - near side (left side).
I have it apart (again) at the moment, dressing any burrs, looking for 'rubbing' etc.

Thanks Will & Bob - I took care to get the speedo drive tongues aligned and yes it has the spacer 4352-56, the speedo drive centre locks into position.
I started the bike and ran it in gear briefly on a lift with the offside spindle nut not quite fully tight, the speedo works smoothly.

The wheel ...

I am trying to sort out an original HT5 that has been off the road for decades, installing the rear wheel, which has the speedometer drive, I can lock up near side spindle nut no problem. When I lock up the off side nut, the wheel progressively drags the tighter the nut and stops free wheeling.
The ...

Thanks Keith, that's very useful and encouraging that that the Feked guide needed a little reaming. I hadn't even thought of Feked although now I do.

That's great, thanks Simon, I did try to search, also searched Draganfly site - I must be doing it wrong.
Anyway thanks again, that's got me going.

Hi, Can anyone confirm the correct stem diameter of the exhaust valve for late alloy head model (part No. 441-55) and what the clearance should be in the guide (part No. 491-55). Thanks.

Thank you for the help everyone - I did manage to obtain what I was looking for.
Great Club - help is there when needed.

ariel.andersen wrote:Hi Mark.
I you haven’t found one I can help with a complete front hub.
If interest Mail to:
<Ariel.andersen@godmil.dk>
Regards
Jorgen

Thank you - email on its way to you.