Hi all,
Is there a recommended tightening torque for the nuts on the big end caps please? I remember being surprised at how tight they were when removing them, given that the other end is in aluminium but wasn't sure just how tight is tight-enough when refitting.
Cheers
Graham
Big end cap tightening torque?
-
- Holder of a Nylon Anorak
- Posts: 169
- Joined: Thu Apr 07, 2011 6:22 pm
- Location: Lancashire, England
- Contact:
- adrie.degraaff
- Holder of a Golden Anorak
- Posts: 3275
- Joined: Sun Feb 27, 2011 10:07 am
- Location: Holland
- Contact:
Re: Big end cap tightening torque?
Hi
Last edited by adrie.degraaff on Sat Dec 31, 2011 2:05 pm, edited 1 time in total.
- brenton.roy
- Holder of a Golden Anorak
- Posts: 2056
- Joined: Sun Feb 27, 2011 1:13 pm
- Location: Adelaide, South Australia
- Contact:
Hi Graham, I'm not aware of much info about torque settings. This is the factory sheet - from Roger at Drags. http://www.barkshire.co.uk/AOMCC/Knowle ... spx?id=245 (divide by 12 to get to foot pounds)
Brenton
Brenton
'51,'56 Squares, '48 VH, '27 Model C, R67/2, Mk IV Le Mans, '06 Super Duke and Ariel projects.
-
- Holder of a Nylon Anorak
- Posts: 169
- Joined: Thu Apr 07, 2011 6:22 pm
- Location: Lancashire, England
- Contact:
Who is online
Users browsing this forum: No registered users and 20 guests