Crank half bolt
-
DavidTetley
- Posts: 10
- Joined: Sat May 24, 2014 11:16 pm
- Contact:
Crank half bolt
Can someone tell me the torque setting for the cap head holding the two flywheels together?
-
bh.sprint
- Holder of a Waxed Cotton Anorak
- Posts: 425
- Joined: Wed Oct 31, 2012 7:21 pm
- Location: South Yorkshire
- Contact:
Re: Crank half bolt
Hello David,
The workshop manual gives a figure of 60 ft/lbs. If the flywheels do not line up to the .001 run out, try tightening them up in stages truing them at each stage.
Brian.H.
The workshop manual gives a figure of 60 ft/lbs. If the flywheels do not line up to the .001 run out, try tightening them up in stages truing them at each stage.
Brian.H.
Who is online
Users browsing this forum: No registered users and 28 guests