Re: cylinder to head mating question - w/ng
Posted: Fri Jan 27, 2023 6:29 pm
With the head tightened down, there is no gap, none at all, not even 0.001".
I shall have to remove the bolts to measure without them fitted, but I don't hold out much hope.
If there is no gap, then I am thinking that I will have to try making a copper gasket as per John Nash's suggestion to sit on top of the spigot. Is there a particular type of copper which I should try and find? approx. 0.025" do you think?
I shall have to remove the bolts to measure without them fitted, but I don't hold out much hope.
If there is no gap, then I am thinking that I will have to try making a copper gasket as per John Nash's suggestion to sit on top of the spigot. Is there a particular type of copper which I should try and find? approx. 0.025" do you think?