Ariel Owners Motorcycle Club

Evening all,
Does anyone know of a supplier for the carrier p/n 5630-41?
If not, does the club have a works drawing?

Regards

Steve

hi have you been onto Drags or try john budgen he may have one

These guys have it on their site:
http://www.parkwoodproducts.co.uk/racks.html

hi parkwood is very good i see him at kempton park motorcycle autojumble i forgot about him i did put a post about him under supplies a while back on this forum

Excellent, thank you very much for all your help.

Steve,

Parkwood are out of stock and according to them they are not expecting them for a number of months sadly

Adam

hi drags are saying they now have them in stock now according to the news letter today

I rang drags today as I am also looking for one and they don't have any, with none in the making either. They did say pop your info on the website in the pro-forma at the bottom of the carrier page to register your interest, maybe they will decide to produce some.

I would say they do not look overly difficult to produce a one off if you have a pipe bender, welder and if you had the measurements.

I am sure I saw a post on a website somewhere which had the measurements!? Will see if I can remember where as I would say i will need them too soon...

Adam

There are three posts on my blog showing how I made mine - the dimensions came from Vincent van Ginneke, on this very forum.

I used round bar, its easier to get the bends neat than using tube.

This is the first one:

https://ariel-square-four.blogspot.com/ ... k.html?m=0

Second one:

https://ariel-square-four.blogspot.com/ ... 2.html?m=0

Last one:

https://ariel-square-four.blogspot.com/ ... 3.html?m=0

Simon, excellent! Everything we need to make one up

Thank you!

Adam