Thank you for the offer Steve!
I have access to equipment where I quite enjoy making smaller parts for my projects so will have a go with the dimensions provided for now.
It is amazing to know that with the help of this forums members we can get assistance with these model specific hard to find parts!
Mamy thanks
Adam
Dimensions for tool box clip 6560-41
-
- Holder of a Nylon Anorak
- Posts: 188
- Joined: Sun Oct 30, 2022 9:53 am
- Location: Nr Poole, Dorset
- Contact:
Re: Dimensions for tool box clip 6560-41
Thanks for the advice Simon.
Being 1944, my bike is hand painted in good old olive drab.
The forum is really helpful, I agree. Don't how we would manage without the collective wisdom.
Steve
Being 1944, my bike is hand painted in good old olive drab.
The forum is really helpful, I agree. Don't how we would manage without the collective wisdom.
Steve
- Wali.Badger.Taylor
- Holder of a Waxed Cotton Anorak
- Posts: 364
- Joined: Mon Feb 28, 2011 8:48 pm
- Location: Birmingham, the new Jerusalem
- Contact:
Re: Dimensions for tool box clip 6560-41
I am confused about the offset in the clip for the rear of the two boxes, are they of two different depths and the offset there to put the front faces flush or does the front of the lower box protrude in front of the upper? I have a genuine split box (upper) and a genuine Ariel (but not WNG)lower box and they are of the same depth.
Re: Dimensions for tool box clip 6560-41
Hi,
Mine are of different depths and I tailored the offset so that both lids were at the same level.
You could make your offset suit your toolboxes as long as they don't get held off by the mudguard behind.
Adam
Mine are of different depths and I tailored the offset so that both lids were at the same level.
You could make your offset suit your toolboxes as long as they don't get held off by the mudguard behind.
Adam
- Wali.Badger.Taylor
- Holder of a Waxed Cotton Anorak
- Posts: 364
- Joined: Mon Feb 28, 2011 8:48 pm
- Location: Birmingham, the new Jerusalem
- Contact:
Re: Dimensions for tool box clip 6560-41
Thank you Adam that is just what I needed to know and will bend up a pair on Wednesday.
Who is online
Users browsing this forum: No registered users and 1 guest