Ariel Owners Motorcycle Club

I'm just about to refit the timing side cover on my Huntmaster restoration. I've got the 12 screws but not sure without a lot of trial and error as to which length goes where. Is there a diagram available? Any help much appreciated. Frank

Hi

There's only three differing lengths of screw, just measure the depth of the holes to the mating face of the inner cover with a bit of stiff wire and it will all become obvious - so easy I didn't make a note of it

Regards Mick

Doh! Why didn't I think of that? Just don't tell my wife!! Thanks a lot anyway.

hi i had the same thing when i was putting my engine and gearbox together i did look at Drags site but i found the listing of screws not a 100% right so i done the same as what Mick says