Hi all
I am looking to have a pair of arrow cylinders taken out to plus 40. What sort of price should I expect to pay, and any info on where to go as I am in Hampshire.
cheers Bob K
Arrow rebore wanted.
-
- Holder of a Nylon Anorak
- Posts: 113
- Joined: Sun Oct 02, 2011 1:09 pm
- Contact:
- Steven.Carter
- Holder of a Platinum Anorak
- Posts: 4311
- Joined: Mon Feb 28, 2011 4:45 am
- Location: Eastleigh, Hampshire
- Contact:
Re: Arrow rebore wanted.
Try these people, I've had my huntmaster done a couple of times, no problems
Owlesbury Crankshaft Service
Unit 12 Winnall Valley Road
Winnall
Winchester
SO23 0LD
Telephone : 01962 855969
Fax : 01962 856969
Email : sales@ocservice.co.uk
Owlesbury Crankshaft Service
Unit 12 Winnall Valley Road
Winnall
Winchester
SO23 0LD
Telephone : 01962 855969
Fax : 01962 856969
Email : sales@ocservice.co.uk
-
- Holder of a Nylon Anorak
- Posts: 113
- Joined: Sun Oct 02, 2011 1:09 pm
- Contact:
Re: Arrow rebore wanted.
hi Steve
That s two recommendations for O.C.S I will check them out on monday.
cheers Bob K
That s two recommendations for O.C.S I will check them out on monday.
cheers Bob K
-
- Posts: 94
- Joined: Sat Feb 20, 2016 10:34 am
- Location: swindon
- Contact:
Re: Arrow rebore wanted.
south cerney engineering near cirencester glos can do rebores from 2" bore upwards .
they are motor engineers .
they are motor engineers .
-
- Holder of a Nylon Anorak
- Posts: 113
- Joined: Sun Oct 02, 2011 1:09 pm
- Contact:
Re: Arrow rebore wanted.
Hi Ian
Thanks for the though but have gone with the firm in Winchester and time will tell if I was right.
Cheers Bob K
Thanks for the though but have gone with the firm in Winchester and time will tell if I was right.
Cheers Bob K
-
- Holder of a Nylon Anorak
- Posts: 113
- Joined: Sun Oct 02, 2011 1:09 pm
- Contact:
Re: Arrow rebore wanted.
Hi all
I have just collected my rebore from OCS in Winchester and things are looking good so roll on the next couple of weeks for a rebuild of my projects motor.
Cheers BobK
I have just collected my rebore from OCS in Winchester and things are looking good so roll on the next couple of weeks for a rebuild of my projects motor.
Cheers BobK
Who is online
Users browsing this forum: No registered users and 17 guests