54 SQUARE 4 WONT SWITCH OFF
Posted: Sun Dec 01, 2019 11:42 am
Done everything to this bike including engine rebuild and straightening the frame in my jig. Replaced several electrical components with standard like for like. Recon dyno as well. Made a new wiring harness. Maybe I'm wrong but I thought an ignition switch would stop current going to the distributor and coil. Turned off it continues to run and my assumption is current from the dyno is not isolated. Switch turned off and turning the light switch to the right does stop it running. Cleaned the contacts of the Lucas regulator which makes no difference. Maybe thats how it works...any advice much appreciated.
After tea and biscuits I thought I should high light the fact that the light switch 31315 shown on Draganfly website was fitted in lieu of the
the broken seven pole switch. This switch has six poles however, the wiring diagram shows seven poles one of which is not used.
All circuits have continuity and receive acceptable voltage.
Thought I'd get this one off my chest as well. There are three wiring diagrams for this model. One major difference relates to the positive earth.
The last diagram indicates shows earth wire from battery to regulator with one earth connection followed by a second earth.
The other two diagrams show a wire from battery to earth and a wire from regulator to the same earth point. Which is best ?
After tea and biscuits I thought I should high light the fact that the light switch 31315 shown on Draganfly website was fitted in lieu of the
the broken seven pole switch. This switch has six poles however, the wiring diagram shows seven poles one of which is not used.
All circuits have continuity and receive acceptable voltage.
Thought I'd get this one off my chest as well. There are three wiring diagrams for this model. One major difference relates to the positive earth.
The last diagram indicates shows earth wire from battery to regulator with one earth connection followed by a second earth.
The other two diagrams show a wire from battery to earth and a wire from regulator to the same earth point. Which is best ?