Wanted NH350 cam 1750-54 and pinion

[dennis.t]

Wanted NH350 cam 1750-54 (single lobe) and pinion. Fits all late singles. Also wide type cam followers if possible.
Many thanks, Dennis

[JohnnyBeckett]

hi i would keep looking on Ebay this time of year a lot Ariel parts come up i think a lot of people need money after christmas and the new year, i buy a lot of parts etc this time of year, and i have had some very good deals

[Simon.Gardiner]

Dennis - you might need to check out Drags for these....

SG

[dennis.t]

Thank you both for your advice. I have been looking on eBay but with no luck so far; I shall keep looking into the New Year.
As for Drags, I inferred from their web site information that they only do an exchange service for cam re-grinds and I have no cam to exchange. I note that they do sell the cam pinion so that is helpful.
Dennis

[nevhunter]

It's possible to make the Camshaft from scratch but the wide followers might be a tall order. Keep trying. . If one was available what would be a fair price do you think? I have acquired a few brand new cams over the years but none of them were single lobe. Nev

[adrie.degraaff]

I have a good singlelobecam and wide followers for you but all depending on what you are prepaired to pay and there is the sending.

[dennis.t]

Adrie,
Private message sent.
Regards,
Dennis

[dennis.t]

Nev,
I have no idea what a fair price would be for a single lobe cam. This is only my second Ariel restoration and the VH came with the timing side intact.
You seem to suggest that a single lobe cam for the NH is rare? Is it the case that the two cam, slim followers combination is more common? I had assumed that I needed a single cam. Are you aware of any technical information on the subject?
Regards,
Dennis

[dennis.t]

Nev,

I found this with a search on our forum:

http://www.arielownersmcc.com/members_o ... rticle.doc
It seems to be a definitive article on Ariel cams
Denis

[dennis.t]

I have the parts now thank you.