Wanted :
Single timing house casting in bad shape
The bit towards the magdyno may be broken off, edge damaged, oil attachments broken, whatever.
But the round part holding the cam and followers pin should be o.k.
I want to mill holes in it at pushrod end level to check on the seating - followers/pushrods.
My (not yet build in) WNG engine makes a 'clacking' noise when cranked over by hand , I suspect one (or both) pushrod tilting itself from the cup on the camfollower and falling back in it's cup.
PM me if you have something please, Thanks !
Wanted late single timing house
- Vincent.vanGinneke
- Holder of a Platinum Anorak
- Posts: 4311
- Joined: Sat Apr 09, 2011 12:14 am
- Location: "The Dutch Branch"
- Contact:
- Vincent.vanGinneke
- Holder of a Platinum Anorak
- Posts: 4311
- Joined: Sat Apr 09, 2011 12:14 am
- Location: "The Dutch Branch"
- Contact:
Re: Wanted late single timing house
Found what I wanted
Who is online
Users browsing this forum: Bing [Bot] and 14 guests