Having read Rob's report in 07/23 CdF about fitting an oil pressure switch to his KH I wonder what would be the best way to fit such a switch to my Mk2. I think it needs to be fitted to/in between the oil feed line to the rockers. Any ideas welcome!
Thanks Klaus
oil pressure switch for my 53 Mk2
-
klaus gerhard
- Holder of a Nylon Anorak
- Posts: 285
- Joined: Tue Nov 01, 2011 8:18 am
- Location: Erlangen, Germany
- Contact:
-
Roger Gwynn
- Holder of a Golden Anorak
- Posts: 1163
- Joined: Tue May 28, 2013 11:34 am
- Location: Norwich, UK
- Contact:
Re: oil pressure switch for my 53 Mk2
This was how I fitted one to my bike, not very neat but it was being used as a test bed for various ideas. If i can get it sorted you may well see it in Austria but there is a lot to do as it hasn't run since 2012 and more than a few bits have been 'borrowed' to use as patterns.
Roger Gwynn, Membership Secretary, curator of the Machine Register and the works drawings. Director of Draganfly Motorcycles, Craven Equipment and Supreme Motorcycles mostly retired.
-
dave.owen
- Holder of a Golden Anorak
- Posts: 1812
- Joined: Wed Mar 23, 2011 10:05 pm
- Location: swindon
- Contact:
Re: oil pressure switch for my 53 Mk2
If I remember I'll get photo of the oil pressure switch on my mk11
AOMCC Treasurer
-
nevhunter
- Holder of a Platinum Anorak
- Posts: 5055
- Joined: Tue May 10, 2011 9:42 am
- Location: Victoria.. Australia.
- Contact:
Re: oil pressure switch for my 53 Mk2
A lot of mowers and Industrial motors have oil pressure switch cut outs for safety. They are quite small. Nev
-
klaus gerhard
- Holder of a Nylon Anorak
- Posts: 285
- Joined: Tue Nov 01, 2011 8:18 am
- Location: Erlangen, Germany
- Contact:
Re: oil pressure switch for my 53 Mk2
Thanks very much. I will fit a switch as mentioned for piece of mind.
Regards Klaus
Regards Klaus
Who is online
Users browsing this forum: No registered users and 0 guests