Brake lever stop bolt
-
- Holder of a Nylon Anorak
- Posts: 226
- Joined: Sun Jan 25, 2015 4:58 pm
- Location: Lancashire UK
- Contact:
Brake lever stop bolt
Hello, I bought a nice looking 5718-37 rear brake pedal stop bolt from Acme a while ago and tried to fit it to my 1950 NH rigid project and I cannot see where it goes and what it does. Can anyone explain or share a photo please?
- simon.holyfield
- Holder of a Platinum Anorak
- Posts: 4697
- Joined: Mon Oct 17, 2011 11:16 pm
- Location: Norfolk
- Contact:
Re: Brake lever stop bolt
Here you go. It's the special bolt right under the clutch that retains the primary case to the frame:
There's a post about it here:
https://ariel-square-four.blogspot.com/ ... l.html?m=0
There's a post about it here:
https://ariel-square-four.blogspot.com/ ... l.html?m=0
cheers
Simes
'51 Square Four,
'58 Huntmaster,
'42 W/NG,
'30 Model A
https://ariel-square-four.blogspot.com
Simes
'51 Square Four,
'58 Huntmaster,
'42 W/NG,
'30 Model A
https://ariel-square-four.blogspot.com
-
- Holder of a Nylon Anorak
- Posts: 226
- Joined: Sun Jan 25, 2015 4:58 pm
- Location: Lancashire UK
- Contact:
Re: Brake lever stop bolt
Thanks Simon, it’s the correct length and diameter to fit there but I thought it would make the brake pedal position too low, obviously no so. I should have actually fitted it first so will try again. Thank you
Who is online
Users browsing this forum: No registered users and 1 guest