Wanted WNG Brake Plate

Post Reply
olaf.suess
Holder of a Nylon Anorak
Holder of a Nylon Anorak
Posts: 116
Joined: Tue Apr 26, 2011 7:32 pm
Contact:

Wanted WNG Brake Plate

Post by olaf.suess »

Hello
Search a front brake plate for Ariel WNG in good condition. Best regards
26'C, 27'C,28'C,31'MF, 38' RH, 43' W/NG
User avatar
rein.heerkens
Posts: 92
Joined: Fri Feb 18, 2011 9:11 pm
Location: Dinther, The Netherlands
Contact:

Re: Wanted WNG Brake Plate

Post by rein.heerkens »

I think I have one, will have a look tomorrow.
nevhunter
Holder of a Platinum Anorak
Holder of a Platinum Anorak
Posts: 5075
Joined: Tue May 10, 2011 9:42 am
Location: Victoria.. Australia.
Contact:

Re: Wanted WNG Brake Plate

Post by nevhunter »

When you get one set it up on a straight axle between good nuts and see how true it runs. IF there's any wobble correct it. The speedo drive and the gears are expensive and hard to find so the ones in the hub must mesh as well as can be achieved. I'd recommend you use nonfling grease and apply it fairly regularly as you can't put much on as it gets on the brakes if you apply too much. I wrecked a set of gears as I neglected an often used bike at one stage. Check also your speedo cable and the speedo itself are free to rotate easily. Nev
olaf.suess
Holder of a Nylon Anorak
Holder of a Nylon Anorak
Posts: 116
Joined: Tue Apr 26, 2011 7:32 pm
Contact:

Re: Wanted WNG Brake Plate

Post by olaf.suess »

Thanks ... I have one.
26'C, 27'C,28'C,31'MF, 38' RH, 43' W/NG
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests