Removing & Installing Sq4 motor Part 2

Bikes or not. Whatever
Post Reply
User avatar
chris.shearwood
Holder of a Silver Anorak
Holder of a Silver Anorak
Posts: 646
Joined: Mon Feb 28, 2011 5:28 pm
Location: Sutton, Quebec, Canada
Contact:

Removing & Installing Sq4 motor Part 2

Post by chris.shearwood »

7A.jpg
8A.jpg
Then the smaller piece of plywood was bolted to the U-shaped one. By zooming in on the photo one can just make out the nut on the bottom of the nearest bolt. These two nuts prevent the drill rods from spreading apart. A couple of screws are screwed into the top support block to prevent the rods from coming closer together.
9A.jpg
11A.jpg
10A.jpg
1946 4G and 1951 VH
Post Reply

Who is online

Users browsing this forum: allan.walker and 3 guests