WNG

General talk about the W/NG
nevhunter
Holder of a Platinum Anorak
Holder of a Platinum Anorak
Posts: 5026
Joined: Tue May 10, 2011 9:42 am
Location: Victoria.. Australia.
Contact:

Re: WNG

Post by nevhunter »

I'll check thru min e at some stage. I know there is one on a bike. I could never work out what "test" was for. Nev
ariel.andersen
Holder of a Waxed Cotton Anorak
Holder of a Waxed Cotton Anorak
Posts: 426
Joined: Mon Oct 24, 2011 6:41 am
Contact:

Re: WNG

Post by ariel.andersen »

To all.
Thank you for the response.
If some one have interest in the plate I will swap ore sell it.
Regards
Jorgen
wade.edwards
Holder of a Silver Anorak
Holder of a Silver Anorak
Posts: 687
Joined: Thu Mar 10, 2011 5:48 am
Location: British Columbia
Contact:

Re: WNG

Post by wade.edwards »

OK, Nev, got an extra "TEST" switch under the bench? :D
nevhunter
Holder of a Platinum Anorak
Holder of a Platinum Anorak
Posts: 5026
Joined: Tue May 10, 2011 9:42 am
Location: Victoria.. Australia.
Contact:

Re: WNG

Post by nevhunter »

Sorry Wade, I didn't see this post and reply to you at the time.. If I can get another switch with TEST on it I will get back to you. I'm looking for the "P" push button switch and the blanked plate where the ammeter used to go. Incidently I've found the lights go from the Mainbeam filament (One wire only of the two connections) to the park filament, not high and low beam. This info is in the Maintenance manual for the W/NG (101/A1. 3B). the "test" operates the tail light IF the generator is working. the full wiring info is also in the above publication. There is only ONE wire shown going into the headlamp shell, but I would also run an earth wire, myself. regards Nev
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest