Huntmaster timing side cover screws
-
- Posts: 43
- Joined: Wed Apr 25, 2018 2:09 pm
- Location: South Yorkshire
- Contact:
Huntmaster timing side cover screws
I'm just about to refit the timing side cover on my Huntmaster restoration. I've got the 12 screws but not sure without a lot of trial and error as to which length goes where. Is there a diagram available? Any help much appreciated. Frank
Re: Huntmaster timing side cover screws
Hi
There's only three differing lengths of screw, just measure the depth of the holes to the mating face of the inner cover with a bit of stiff wire and it will all become obvious - so easy I didn't make a note of it
Regards Mick
There's only three differing lengths of screw, just measure the depth of the holes to the mating face of the inner cover with a bit of stiff wire and it will all become obvious - so easy I didn't make a note of it
Regards Mick
-
- Posts: 43
- Joined: Wed Apr 25, 2018 2:09 pm
- Location: South Yorkshire
- Contact:
Re: Huntmaster timing side cover screws
Doh! Why didn't I think of that? Just don't tell my wife!! Thanks a lot anyway.
-
- Holder of a Golden Anorak
- Posts: 2381
- Joined: Sat Jul 07, 2018 5:39 pm
- Contact:
Re: Huntmaster timing side cover screws
hi i had the same thing when i was putting my engine and gearbox together i did look at Drags site but i found the listing of screws not a 100% right so i done the same as what Mick says
Who is online
Users browsing this forum: No registered users and 3 guests