Huntmaster timing side cover screws

Singles, twins and fours.
Post Reply
FrankBeevers
Posts: 43
Joined: Wed Apr 25, 2018 2:09 pm
Location: South Yorkshire
Contact:

Huntmaster timing side cover screws

Post by FrankBeevers »

I'm just about to refit the timing side cover on my Huntmaster restoration. I've got the 12 screws but not sure without a lot of trial and error as to which length goes where. Is there a diagram available? Any help much appreciated. Frank
Mick D
Holder of a Waxed Cotton Anorak
Holder of a Waxed Cotton Anorak
Posts: 575
Joined: Tue Nov 27, 2018 2:49 pm
Contact:

Re: Huntmaster timing side cover screws

Post by Mick D »

Hi

There's only three differing lengths of screw, just measure the depth of the holes to the mating face of the inner cover with a bit of stiff wire and it will all become obvious - so easy I didn't make a note of it :(

Regards Mick
FrankBeevers
Posts: 43
Joined: Wed Apr 25, 2018 2:09 pm
Location: South Yorkshire
Contact:

Re: Huntmaster timing side cover screws

Post by FrankBeevers »

Doh! Why didn't I think of that? Just don't tell my wife!! Thanks a lot anyway.
JohnnyBeckett
Holder of a Golden Anorak
Holder of a Golden Anorak
Posts: 2381
Joined: Sat Jul 07, 2018 5:39 pm
Contact:

Re: Huntmaster timing side cover screws

Post by JohnnyBeckett »

hi i had the same thing when i was putting my engine and gearbox together i did look at Drags site but i found the listing of screws not a 100% right so i done the same as what Mick says :D :D
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests