Thanks Pete and Rob.
I had already seen the Draganfly catalogue and the shims but thought some one would have a figure like 5 to 8 thou. I wonder if the new gaskets are thicker??
Ed
Search found 9 matches
- Tue May 14, 2013 7:54 pm
- Forum: Four stroke
- Topic: NH Camshaft end-float
- Replies: 6
- Views: 2820
- Tue May 14, 2013 12:57 pm
- Forum: Four stroke
- Topic: NH Camshaft end-float
- Replies: 6
- Views: 2820
NH Camshaft end-float
I have scanned through all the literature that I have but can find no reference to camshaft end float. I have re-assembled my NH cam and followers with the original shims and have now measured the end float. It is 17 thou. To me that looks excessive.
Can anyone give me an exact figure?
Can anyone give me an exact figure?
- Tue Apr 23, 2013 7:53 am
- Forum: Suppliers
- Topic: Brake Linings
- Replies: 1
- Views: 1891
Brake Linings
Just had my NH Brake Linings replaced by Villiers Services, Brierly Hill. These are bonded and a non-asbestos fabric weave that will not damage your drums. They turned around 8 days from posting to receiving them back. They were also the cheapest quote. (Cost £17.50 including postage, packing and VA...
- Wed Mar 06, 2013 7:15 pm
- Forum: Main Chat Forum
- Topic: 1954 NH front wheel (1/2 width hub)
- Replies: 8
- Views: 3504
John, Thanks for your work on this. the bike didn't have a wheel when I bought it, so I was not able to photograph, take measurements and notes of the front wheel. I am going to wait a while. Perhaps there will be an NH at the AGM that i can scrutinise? There's no rush, as this project is no where n...
- Tue Mar 05, 2013 9:02 pm
- Forum: Main Chat Forum
- Topic: 1954 NH front wheel (1/2 width hub)
- Replies: 8
- Views: 3504
- Mon Mar 04, 2013 8:48 pm
- Forum: Main Chat Forum
- Topic: 1954 NH front wheel (1/2 width hub)
- Replies: 8
- Views: 3504
- Sun Mar 03, 2013 9:33 pm
- Forum: Main Chat Forum
- Topic: 1954 NH front wheel (1/2 width hub)
- Replies: 8
- Views: 3504
1954 NH front wheel (1/2 width hub)
Does any one know whether the front wheel has an offset, when it is built? I surmise that it does owing to the fact that it touches the inner fork on the brake side but that there is a gap(10 mm ?) on the near side. My rebuild is getting to the stage where I need this information. Any knowledgeble g...
- Wed Feb 27, 2013 10:00 pm
- Forum: Four stroke
- Topic: NH 350 Front Wheel Spindle
- Replies: 2
- Views: 1514
Re: NH 350 Front Wheel Spindle
David,
Thanks for the confirmation.
Ed
Thanks for the confirmation.
Ed
- Tue Feb 26, 2013 2:12 pm
- Forum: Four stroke
- Topic: NH 350 Front Wheel Spindle
- Replies: 2
- Views: 1514
NH 350 Front Wheel Spindle
Hi,I am rebuilding a very sad NH 1954. Please can anyone give me the overall length measurement of the half-width front wheel spindle? Mine appears to be too short at 8 1/2"
Thanks
Ed
Thanks
Ed