The cut away on my locating plate pin is slightly convex, it does fit in very well and makes the crank removal/installing very easy. Brian H.

The bar goes through both flywheels, yes there is a flat on the end to allow it to go past the big end. Brian H

I used two types of modern material on the clutch plates and found both to give clutch drag even though the max amount of movement was being used and sometimes slip. Tried adding slots to the surface but this did not make any difference, although I have heard of others using slots and reported a bet...

Ariel supplied 49,47 and 45 tooth rear sprockets, not seen any 45 tooth ones but have seen a 50 tooth one! My Arrow has 18 '' wheels and a 52 tooth sprocket- tried a 51 tooth but it was just a little too high . The workshp who made the adaptor from a worn Ariel one have been taken over so may not st...

Will reply with more detail later when I have more time. I've used modern plates and found them very poor- sip and drag. Brian H

Try Vehicle Wiring Products Ilkeston for a stop light switch. Brian H

Hello Paul,

You may have guessed but the person who specialises in indicators is Roger Lee. from th next village/town to Drags. He always has some indicator bits on his stall at the Rallies. I'll put his tel. number on the message facility-if it works. Brian

I got one from Vehicle Wiring of Ilkeston not a perfect match but near,I had to extend the lever and add a bit more feel to the notch ' Or you could try the Aomcc indicator specialist ,number sent if needed via private messages or similar. Brian H

Hi, The Armours silencers have very basic baffels in them, just four discs. You can fit original baffels but need to reduce the size of the baffels slightly. I used some end tubes , the 1'' diameter ones to reduce the sound a bit. The picture shows the original ones at the bottom and some modified A...

The contact details of the spares organisers ,badges and regalia are in the Cheval magazine ,just inside the cover. Brian H