Search found 15 matches
- Sat Sep 26, 2015 7:12 am
- Forum: Electrics
- Topic: Ignition problem
- Replies: 4
- Views: 3048
Re: Ignition problem
Thank's for the replies. The cable connection is ok and the face cam is right as far as i know. I'll check the letter. An idea! Can it be wrong angle on the shaft in comparsion to the windings? I have read somewhere that its important that the windings are in right position when the ignition starts.
- Tue Sep 15, 2015 7:22 pm
- Forum: Electrics
- Topic: Ignition problem
- Replies: 4
- Views: 3048
Ignition problem
Hi! I have a VH500 1951. After 15 yaers the magneto was a little bit tired. I change to another magneto but another problem came in. When I drive and try to advace the timing to a good point, suddenly the engine stops fireing. When I put the leaver a little bit back it starts fireing again. The exha...
- Sat Jun 01, 2013 8:17 am
- Forum: Four stroke
- Topic: making pushrods
- Replies: 8
- Views: 3168
Hi! I have a mixt engine with VB crankcase, OHV dual exhaust top and and a cylinder with 85mm BSA piston. It's a spacer plate under the cylinder and my question is about the pushrods. I have two models, one is 12mm diameter and heaver then the other 11mm diameter and lighter. Some one has make the l...
- Tue Mar 12, 2013 8:33 pm
- Forum: Four stroke
- Topic: Which pistons are available for my ariel
- Replies: 145
- Views: 107944
- Tue Mar 12, 2013 7:31 pm
- Forum: Four stroke
- Topic: Which pistons are available for my ariel
- Replies: 145
- Views: 107944
- Mon Oct 15, 2012 7:53 pm
- Forum: Four stroke
- Topic: Sturmey Archer Gearbox
- Replies: 0
- Views: 1098
Sturmey Archer Gearbox
Hi!
I have a Sturmey Archer gerbox on my bench in parts. My problem is that there are two shims with differnt inner diameter and I don't know where to put them. Is any body know?
Regards: Kjell from Finland!
I have a Sturmey Archer gerbox on my bench in parts. My problem is that there are two shims with differnt inner diameter and I don't know where to put them. Is any body know?
Regards: Kjell from Finland!
- Tue Jun 07, 2011 9:31 pm
- Forum: Four stroke
- Topic: Big end bearing
- Replies: 23
- Views: 12801
- Mon Jun 06, 2011 5:46 pm
- Forum: Four stroke
- Topic: Big end bearing
- Replies: 23
- Views: 12801
- Sun Jun 05, 2011 7:00 pm
- Forum: Four stroke
- Topic: Big end bearing
- Replies: 23
- Views: 12801
- Wed Jun 01, 2011 7:53 pm
- Forum: Four stroke
- Topic: Big end bearing
- Replies: 23
- Views: 12801