Hi all I’m looking for girder fork yokes for my VH project.
My mobile number is 07730312052

Many thanks Simon

Hi all. I am looking for girder fork yokes for my VH project.
My mobile number is 07730312052

Many thanks Simon

:) Thanks for the replies chaps. Yes Simon, I will look into what can be done with the engine sprocket although I don’t recall there being a space behind it on the BSA. I think the engine sprocket has a shoulder on the back of it that gives it the spacing. Of cause I could get that machined down sli...

Hi guys. I’ve fitted a BSA A10 into a 58 Ariel frame. I assumed that this would be an easy enough job as I thought the engine was basically the same in many ways to the FH. Well I’ve already found that it isn’t quite the same as FH engine plates weren’t quite right to pick up the mounting holes in t...

Due to the fact that I have acquired a 650 engine for my special, I have for sale a freshly re-built ally head NH 350 engine. Only covered 200 miles New main bearings, seal, nos WNG piston and re-bore, valves. Runs very well £500 Recently re-built M01 magneto £200 New (apart from covering 200 miles)...

Not mine and I don’t know any details other than it’s a 600cc ohv. 07399409535

I’m not in any way an expert but I had similar power issues with my ally head NH when it got hot. I have a feeling mine was at least partially caused on the fueling side of things. It seams better after fitting an insulating spacer between carb and head.

Could be really interesting to have a go at that.

Thanks again John

Yes.. Another good point. Wouldn’t it be nice to have a range of different jets, slides etc I gave Amal a call today and described what I’d tried with needle height etc. The guy I spoke to kindly offered to send me a smaller pilot jet free of charge as he thought it sounded like it wouldn’t be a mai...

Thanks John. Yes, good point. I’ll check the float level. I have to admit, i don’t fully understand how to do it yet.